Power On Access Point 600Mbps RPD-900

RPD900AReview :600Mbps High Speed With 4X4 MIMO technology, the speed and bandwidth of Wireless-N, today’s most advanced wireless technology make it easy for 60~100 users to share internet access; Enjoy media-intensive activities like gaming, video and voice-over-IP phone calls all at once, with less lag and performance degradation. Stylish Ceiling Mount Design: Housed in a stylish ceiling mountable case, the RPD-900 can be installed on a wall or ceiling just as a ceiling lamp and blends in nicely with most interior decorations in a modern hotel. Installed highly on ceiling, it extends optimum wireless signal to multiple neighboring rooms. Power over Ethernet :RPD-900 has integrated IEEE 802.3af Power over Ethernet (PoE) for easy installation and lower cost. So it can be installed in areas where power outlets are not readily available, eliminating the mess of altering existing network infrastructure. VLAN & Access Controller System: With multi SSID up to 8, with 802.1Q standard VLAN, it create a separate, secure, password protected network for guests. With Access Control System, easily access advanced network settings through PC, like AP status monitor, change IP address, ESSID, Channel, Password, upgrade firmware, backup and restore.

 

 


Specs :MCU: MTK MT7620A+Ralink RT3092 RF: 4T4R, 600Mbps MIMO tech , comply with IEEE 802.11N standard,580MHZ Memory: 128MB DDR2 RAM Flash: 16MB SPI Interface: 2 x RJ-45 for 10/100Mbps WAN Port ( WAN Port support POE) 1 x Reset button(Reset & Factory Defaults) 1 x Power DC Jack Power PoE: 48V/0.5A; DC: 12V/1A; 110V/220V Antenna: Build in MIMO 7dbi antenna Size: 18.8*4.5CM
RPD900A RPD900B

Datasheet : pdf_teliko

DoC : cesmall